Question

any tips of solving rubik's cube?

Answer 1

i heard that there's some procedure which is there in net

Answer 2

its a bit difficult though

Answer 3

my friend has mastered it

Answer 4

I think the record is 5.28 seconds, my friend told me.

Answer 5

fridrich f2l

Answer 6

What do you mean?

Answer 7

f2l is cross first, then 2nd layer, OLL, and PLL

Answer 8

But, although fridrich's method is the fastest, she doesn't give the best algs on her guide,

Answer 9

It's also known as CFOP.

Answer 10

You'll want to learn f2l, then move on to advanced f2l while memorizing PLLs, then OLLs.
http://www.cubefreak.net/speed/advancedf2l/normal.php

Answer 11

@FoolForMath derived a formula as i recall

Answer 12

there are simple algorithms for solving it. I can come up with my own:)

Answer 13

i learnt from youtube,,you might too..took me around 2 days to master it..
now my record is 1:55 mins..i know its too much but the quality of my cube is also not vey good..

Answer 14

my method was peel the coloured stickers off .... very easy method 2 master

Answer 15

i used to do that too

Answer 16

why peel of stickers? you can also break the cube and then re-arrange it ;)

Answer 17

i couldn't get it back together properly, some of the pieces got damaged

Answer 18

i thought the sticker method was more temporary than this one..hmmn..

Answer 19

Smash it and put it back together?

Answer 20

Thsoe methods are slower than my time of 35 seconds.

Answer 21

Want to race? @inkyvoyd

Answer 22

My cube is a hard to turn,
if i apply wd40 , goog or bad/

Answer 23

@UnkleRhaukus BAD

Answer 24

ANYTHING PETROLUEM BASED IS BAD.

Answer 25

You'll want something silicone and petroluem; the ptero dries out, whilethe silicon does hte lube job.

Answer 26

o dear too late!

Answer 27

GET IT OFF.

Answer 28

it is sliding pretty good

Answer 29

how?

Answer 30

Tissues. Idk. As much off as you can.

Answer 31

the WD40 will melt your cube over time.

Answer 32

its all over my fingers tooo

Answer 33

which could be good or bad, but it's usually bad.

Answer 34

do you know how to take apart the cube?

Answer 35

i better solve it quickly then

Answer 36

do i really want to do that i broke the last one i had pulling it apart,

the Cube i have at the moment is a little one

Answer 37

A LITTLE ONE?

Answer 38

The thing is going to fall APART!.

Answer 39

It'll melt down to a plastic/wd40

Answer 40

and the cube's peices will sort of get loose and fall out.

Answer 41

its about 3cm^3
if you reckon it will die if i dont pull it apart, how do i procede
?

Answer 42

i mean it is 3cmx3cmx3cm=9cm^3

Answer 43

Let it die (27cm actually)

Answer 44

ah yes multiplication , it just keep growing

Answer 45

how log approximately do i have to solve before it self destructs?

Answer 46

I'm not sure. It might not even break, depending on how much you put in there. It will definitely get looser though.

Answer 47

its sliding like a charm now , except the bits still are not moving into the right places