Questions about inventor:
1. How to make an object solid, as I cant pass through it with another object? I believe that is something about constrains... dont know where go.
2. And how can I find drawning layouts; how to edit borders? I can edit labels, but not all features.
3. And I cant hide that iMate glyphs, by clicking again on botton, like other features.

Here is 2 pictures for comprehension:
http://goo.gl/ZusWa
http://goo.gl/E3Vvj
See ya'

Question

Questions about inventor:
    1. How to make an object solid, as I cant pass through it with another object? I believe that is something about constrains... dont know where go.
    2. And how can I find drawning layouts; how to edit borders? I can edit labels, but not all features.
    3. And I cant hide that iMate glyphs, by clicking again on botton, like other features.

Here is 2 pictures for comprehension:
http://goo.gl/ZusWa
http://goo.gl/E3Vvj
See ya'

anonymous · Answer

1. I think you are talking about surface to surface contact? http://wikihelp.autodesk.com/Simulation_Mechanical/enu/2013/Help/0031-Autodesk31/0237-Setting_237/0271-Analysis271/0319-Nonlinea319/0382-Loads_an382/0389-Surface-389 2. If you right click on the ANSI-Large or whichever you chose you can edit the actual layout of the block in the lower right corner, if you want to edit everything you would go under drawing resources, still on the right, and go and edit whichever one of those folders with the files under then to how you would like it to be. 3. Under the view tab up top there should be the iMateGlyphs which you can toggle whether to show or not.

anonymous · Answer

I was checking with my inventor teacher and he kill my question in 20 seconds. Is that with "set colision" what I was trying to reach. And about that glyphs you're right, @edlevin , thanks a lot; I had problems with my videocard, that was causing lags that makes iMateGlyphs togged on, but now I'ts all right.
Thanks for attention, apreciate that.