Hi, I am working with Laser manufacturer from US who manufactures DPSS High
power Q-Switched [Avg: 22W], TEM00 Green 532nm Laser for diamond cutting. I
need your input about putting rotating 1/2 wave plate [To change the
intensity] after Beam magnifying collimator [input beam diameter 1mm to 8mm
ratio], a beam splitter [passes only P-Polarization] or cube and again put
rotating 1/2 wave plate [Only to rotate Polarization angle] to match the
cutting direction on CNC table, then how you think it should work and what
if this setup needs any modification?
Your input will be very helpful.

Question

Hi, I am working with Laser manufacturer from US who manufactures DPSS High
power Q-Switched [Avg: 22W], TEM00 Green 532nm Laser for diamond cutting. I
need your input about putting rotating 1/2 wave plate [To change the
intensity] after Beam magnifying collimator [input beam diameter 1mm to 8mm
ratio], a beam splitter [passes only P-Polarization] or cube and again put
rotating 1/2 wave plate [Only to rotate Polarization angle] to match the
cutting direction on CNC table, then how you think it should work and what
if this setup needs any modification?
>Your input will be very helpful.